Summary: Cisco Application Centric Design Guide

Study material generic cover image
  • This + 400k other summaries
  • A unique study and practice tool
  • Never study anything twice again
  • Get the grades you hope for
  • 100% sure, 100% understanding
PLEASE KNOW!!! There are just 23 flashcards and notes available for this material. This summary might not be complete. Please search similar or other summaries.
Use this summary
Remember faster, study better. Scientifically proven.
Trustpilot Logo

Read the summary and the most important questions on Cisco Application Centric design guide

  • 6 Overview of Cisco ACI Forwarding

  • 6.1 VXLAN Forwarding Infrastructure

    This is a preview. There are 2 more flashcards available for chapter 6.1
    Show more cards here

  • What is the abbrevition of VXLAN?

    Virtual Extensible LAN
  • 6.1.1 VXLAN Tunnel Endpoints

    This is a preview. There are 8 more flashcards available for chapter 6.1.1
    Show more cards here

  • What is a VTEP?

    A VTEP is a virtual or physical device that maps end devices to VXLAN segments and performs encapsulation and decapsulation
  • What kind of interfaces does the VTEP have?

    -Interface on local segment used to connect end devices
    -Interface on IP transport network used to encapsulate layer 2 frames into udp packets and send them over the transport network
  • What is the abbreviation of PTEP?

    physical tunnel endpoint
  • What is the abbreviation of FTEP and for what is it used?

    Fabric loopback TEP (Tunnel end point)

    Used to encapsulate traffic in VXLAN to a vSwitch VTEP if present
  • What does proxy TEP (PTEP)do?

    Proxy TEP is an anycast address that exists across all spines and is used for forwarding lookups into the mapping database
  • What control-plane protocols are running inside the fabric?

    ISIS (used to maintain infrastructure reachability)
    COOP (runs on on the PTEP loopback to synchronize endpoint database)
    MP-BGP (run on PTEP loopback to advertise external WAN routes through the fabric)
    VXLAN tunnels to PTEPs
  • What is the infrastructure loopback address used for?

    This address is used for communication with the APIC, for MPBGP peering, and for traceroute or ping in the infrastructure
  • What is the vPC loopback  VTEP address loopback address used for?

    this IP address is used when the two leaf nodes forward traffic that enters through a vPC port. Traffic is forwarded by the leaf using the VXLAN encapsulation. This address is shared with the vPC peer
  • What is the Fabric loopback TEP address used for?

    All leaf nodes in the fabric have an IP address to communicate with the VTEP southbound (for instance, with a Cisco Application Virtual Switch [AVS]).
PLEASE KNOW!!! There are just 23 flashcards and notes available for this material. This summary might not be complete. Please search similar or other summaries.

To read further, please click:

Read the full summary
This summary +380.000 other summaries A unique study tool A rehearsal system for this summary Studycoaching with videos
  • Higher grades + faster learning
  • Never study anything twice
  • 100% sure, 100% understanding
Discover Study Smart

Topics related to Summary: Cisco Application Centric Design Guide