Summary: Routing And Switching V5.0
- This + 400k other summaries
- A unique study and practice tool
- Never study anything twice again
- Get the grades you hope for
- 100% sure, 100% understanding
Read the summary and the most important questions on Routing and switching v5.0
-
Test A
This is a preview. There are 5 more flashcards available for chapter 28/05/2016
Show more cards here -
What are the features considered with IPv6 first-hop security? 3
RA guard
DHCP guard
destination guard
RDD -
What are three mode of PFR monitoring?
active mode (based on Cisco SLA probes)
passive mode (based on Netflow)
fast mode (based on Cisco SLA probes) -
Which factors does PFR use to calculate the best exit path? 3
delay
loss
reachability
dlr -
What can PFR passive monitoring measure for TCP flows? 4
-delay
-throughput
-reachability
-packet loss -
What is the purpose of route constraints?
to avoid sending unnecessary BGP VPNv4 or VPNv6 updates to the PE router -
What are the two main phases of PPPoE?
Active discovery phase
PPP session phase
-Active discovery phase – PPPoE client locates a server. A session ID is assigned and the PPPoE layer is established.
-PPP Session phase – PPP options are negotiated and authentication occurs. -
What is the difference between single ISIS and multi topology ISIS?
Single topology:- Shares path calculation with IPv4 routing Table. Only one SPF calculation.
- It requires 1:1 correlation of IPv4 and IPv6 interfaces i.e Ipv4 and IPv6 interfaces should be same.
Multiple topology:- Independent path calculation from IPv4 routing table. Separate SPF calculation.
- IPv4 and IPv6 configuration are completely different i.e IPv4 & IPv6 interfaces can be asymmetric.
https://networkingfolks.wordpress.com/2012/01/21/isis-single-topology-vs-multiple-topology/ -
Which two statement about So0 checking in EIGRP OTP deployment is true?
-During the import process, the So0, value in BGP is checked against the So0 value of the site map
-During the reception of an EIGRP update, the So0 value in the EIGRP update is checked against the So0 value of the the site map on the ingress interface.
http://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/ip-routing/whitepaper_C11-730404.html -
For which configuration sections must you specify the VRF name when configuring DMVPN? 3
crypto keyring
tunnel interface
physical interface -
Which three statements about EVCs are true?
LACP is supported on EVC ports
PAGP is supported on EVC ports
Spanning must use MST mode on EVC ports
- Higher grades + faster learning
- Never study anything twice
- 100% sure, 100% understanding