Verification

7 important questions on Verification

Verification methods during design phase


- Fault tree analysis (FTA)

- Failure mode and effect analysis (FMEA)
- Strength calculation
- Reliability analysis
- Safety analysis
- Model (i.e. software)
- Simulation (dynamic system)
- Design and documentation review (also: by whom?)
- Drawing (top view, profile)
- References (to previous systems or projects)
- Expert judgement (system life time requirements i.e. material choices)

Verification methods during/after realization


oMonitoring: continuous process using measuring equipment
oInspection and measurement report
oTesting
oQuality system
oPhotos
oFAT (Factory Acceptance Test)
oSAT (Site Acceptance Test)
oDrawing (top view, profile)

System engineering deliverables


- OBS: Organization Breakdown Structure
- DBS: Document Breakdown Structure
- Requirement specification
- SBS: System Breakdown Structure
- WBS: Work Breakdown Structure
- Workpackages (‘werkpakketten’)


+ all contract and legal documents!
+ all design documents for techical disciplines!
  • Higher grades + faster learning
  • Never study anything twice
  • 100% sure, 100% understanding
Discover Study Smart

Configuration management: Goal


“to establish and maintain the integrity of all identified outputs of a project or process and make them available to concerned parties”

Configuration management strategy


- Authority for disposition
- Access
- Release
- Control of changes
- Locations and conditions of physical storage or storage media (i.c.o. information)
- Levels of integrity, security, safety


- ISO 10007 (see also Share Point)

A request for change should include:


- Description or justification of the change
- Categorization of the change
    - Complexity
    - Resources
    - Scheduling
- Evaluation of the consequences, impact
- How the change should be dispositioned (which authority?)
- How the change should be implemented and verified

Identification of items under configuration management


- Statutory and regulatory requirements
- Critically in terms of risks and safety
- New or modified technology, design or development
- Interfaces with other configuration items
- Procurement conditions
- Support and service

The question on the page originate from the summary of the following study material:

  • A unique study and practice tool
  • Never study anything twice again
  • Get the grades you hope for
  • 100% sure, 100% understanding
Remember faster, study better. Scientifically proven.
Trustpilot Logo